Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Subaru Forester XT PremiumFACTORY OEM SERVICE PROCEDURE
Idle Speed Control
CAUTION:
After executing the system operation check mode, execute the Clear Memory Mode. < Refer to
OPERATION , Clear Memory Mode. >
- On «System Operation Check Mode» display, select {Idle Speed Control}.
- On «Start the Engine» display, start the engine and click the [OK] button.
- In the «Idle Speed Control» display, click the [↑] button or the [↓] button to change the setting values, then click the [OK] button.
Setting is possible in a range between 500 rpm - 2, 000 rpm, in increments of 50 rpm. However, the engine speed that can actually be controlled will vary depending on the vehicle.
- Click the [Cancel] button to stop the idle speed control.
- Click the [[F12] Exit] button to end the idle speed control. The screen will return to the «System Operation Check Mode» screen.NOTE: For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.