Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Subaru Forester X, Standard TransFACTORY OEM SERVICE PROCEDURE
General Information: Specifications: Forester: At
| Model | 2.5 L non-turbo | 2.5 L turbo | ||
| Transmission | 4AT | 4AT | ||
| Clutch type | TCC | TCC | ||
| Gear ratio | 1st | 2.785 | 2.785 | |
| 2nd | 1.545 | 1.545 | ||
| 3rd | 1.000 | 1.000 | ||
| 4th | 0.694 | 0.694 | ||
| Rev. | 2.272 | 2.272 | ||
| Reduction gear (Front) | First deceleration | Type | Helical | |
| Gear ratio | 1.000 | 1.000 | ||
| Final deceleration | Type | Hypoid | ||
| Gear ratio | 4.444 | 4.111 | ||
| Reduction gear (Rear) | Final deceleration | Type | Hypoid | |
| Gear ratio | 4.444 | 4.111 | ||
4AT: Electronically controlled fully-automatic, 4-forward speeds and 1-reverse
TCC: Torque Converter Clutch
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
