2013 Subaru Forester X, Automatic TransFACTORY OEM SERVICE PROCEDURE

Steering Angle Sensor: Replacement

CAUTION:
  • Do not perform the removal except unless replacing.
  • When replacing three times or more, replace by using the combination switch assembly to protect the threads.
  1. Set the steering wheel in a straight-ahead position.
  2. Disconnect the ground cable from battery.
  3. Remove the driver's airbag module.< Refer to REMOVAL , Driver's Airbag Module. >
    CAUTION: Before handling the airbag module, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM".< Refer to CAUTION , General Description. >
  4. Remove the steering wheel.< Refer to REMOVAL , Steering Wheel. >
  5. Remove the screws and remove the steering column lower cover.
    Fig 1: Locating Steering Column Lower Cover Mounting Screw
    G05957752Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the harness cover lock.
  7. Remove the screws and detach the knee protector.
    Fig 2: Locating Knee Protector Mounting Screws
    G08542325Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the screws and remove the steering column cover upper.
    Fig 3: Locating Steering Column Cover Upper Mounting Screws
    G08542326Courtesy of SUBARU OF AMERICA, INC.
  9. Disconnect the connector of roll connector and steering angle sensor.
  10. Remove the screws which secure the roll connector to steering column.
    Fig 4: Identifying Roll Connector And Mounting Screws
    G08542327Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the vinyl tape binding the harness, and remove the steering angle sensor from roll connector.
    Fig 5: Locating Steering Angle Sensor And Mounting Screws
    G08542328Courtesy of SUBARU OF AMERICA, INC.
  12. Turn the protrusion portion of new steering angle sensor to match the alignment mark of inspection hole.
    CAUTION: Be careful not to allow foreign matter to enter into inspection hole.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.