Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Subaru BRZ Premium, Automatic TransFACTORY OEM SERVICE PROCEDURE
General Information
- How To Read The Repair Information
- Working Precautions And Notes
- Setting Procedures At Parts Replacement And Removal/Installation
- Oils/Coolants
- Troubleshooting Procedures For ECM Control System
- Explanation of basic diagnostic procedures
- Malfunction analysis using check list for interview
- Malfunction symptoms and DTC check
- Procedures for malfunction phenomenon simulation
- List of diagnostic codes
- Symptom table
- Inspection flow by DTC system
- Inspection procedures for electrical circuits and how to perform
- Terminology List
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
