Name: AllOEMManuals
Address: 316 Brandywine Ave, Streetman, TX, 75859, US
Telephone: +14699867883
Price range: $$

Installation of engine control computer bracket
1. Replace the bracket with a new one, engage 2 claws, and attach the engine control computer bracket to the engine control computer.
  CAUTION:
  - After attaching the engine control computer bracket to the engine control computer, do not remove the engine control computer bracket.
  - If the engine control computer bracket has been installed to the engine control computer in the wrong direction, replace the engine control computer bracket with a new one.
Installation of engine control computer
CAUTION: When replacing the engine control computer, do not use the one with a wrong specification.
1. Using 2 nuts, install the engine control computer.
  Standard value: T=7.5N.m {77kgf.cm} {5.5 ft.lbf}
2. Connect 4 connectors for engine control computer.
Installation of control module relay assembly (without smart entry) (Refer to KEY LOCK UNIT )
Installation of glove compartment door assembly (Refer to INSTALLATION )
Installation of instrument side panel RH (Refer to INSTALLATION )
Connection of battery ground terminal
Standard value: T=6.0N.m {61kgf.cm} {4.4 ft.lbf}

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Engine control computer (FA20): Installation