2012 Subaru Tribeca LimitedFACTORY OEM SERVICE PROCEDURE

Select Lever: Installation

  1. Set the select lever to vehicle body.
  2. Tighten the four bolts to install the select lever to vehicle body, and then connect the connector.
    1. Temporarily tighten the bolt A.
    2. Tighten the bolt B.
    3. Tighten the bolt A.
    4. Tighten the bolts C and D.

      Tightening torque: 

      18 N.m (1.8 kgf-m, 13.3 ft-lb) 

      Fig 1: Locating Select Lever Bolts
      G05031900Courtesy of SUBARU OF AMERICA, INC.
  3. Select lever and indicator positions are matched.
    Fig 2: Identifying Select Lever Harnesses
    G05031898Courtesy of SUBARU OF AMERICA, INC.
  4. Install the center console. Refer to INSTALLATION , Center Console.
  5. Install the console box. Refer to INSTALLATION , Console Box.
  6. Shift the select lever to "N" range.
  7. Lift up the vehicle.
  8. Shift the range select lever to the "N" range.
  9. Secure the cable to the bracket. Refer to INSTALLATION , Select Cable.
  10. Adjust the select cable position. Refer to ADJUSTMENT , Select Cable.
  11. After the completion of adjustment, confirm that the select lever operates properly at all range positions.
  12. Install the heat shield cover.
  13. Install the rear exhaust pipe and muffler. Refer to INSTALLATION , Rear Exhaust Pipe. Refer to INSTALLATION , Muffler.
  14. Inspect the following items. When a malfunction is found in the inspection, adjust the select cable. Refer to ADJUSTMENT , Select Cable.
    1. Engine starts when the select lever is in "P" and "N" range, but not in other ranges.
    2. Back-up light illuminates when the select lever is in the "R" range, but not in other ranges.
    3. Install the shift select cable onto select lever.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.