Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmission Control Device: Installation
- Install the detent spring to the transmission case.
Tightening torque:
7 N.m (0.7 kgf-m, 5.2 ft-lb)
- Insert the select lever, and then tighten the bolt.
Tightening torque:
6 N.m (0.6 kgf-m, 4.4 ft-lb)
- Insert the manual plate and parking rod.
- Insert the spring pin to the manual plate.
- Install the oil pan and the control valve body assembly. Refer to INSTALLATION , Control Valve Body.
- Install the pitching stopper bracket.
Tightening torque:
41 N.m (4.2 kgf-m, 30.2 ft-lb)
- Insert the transmission connector to the stay.
- Install the air breather hose. Refer to INSTALLATION , Air Breather Hose.
- Install the torque converter assembly. Refer to INSTALLATION , Torque Converter Assembly.
- Install the transmission assembly to the vehicle. Refer to INSTALLATION , Automatic Transmission Assembly.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.