2012 Subaru Tribeca LimitedFACTORY OEM SERVICE PROCEDURE

Outer Mirror: Replacement

  1. Face the mirror upward.
  2. Disconnect the ground cable from battery. (Model with mirror heater)
  3. Use a flat tip screwdriver to remove clip (A).
  4. Lift the lower mirror up to remove hooks (B).
    Fig 1: Identifying Mirror Clip And Hooks
    G05022632Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect the mirror heater connector from side of the mirror. (Model with mirror heater)
    Fig 2: Identifying Mirror Heater Connector
    G05022633Courtesy of SUBARU OF AMERICA, INC.
  6. Catch the hooks (B) and install clips (A).
    CAUTION:
    • When removing the mirror, be careful not to damage the back surface of mirror with a flat tip screwdriver.
    • When installing the mirror, insert the hook and clip securely.
      Fig 3: Identifying Mirror Hooks And Clips
      G05033492Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.