2012 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Reduction Driven Gear: Disassembly

  1. Remove the ball bearing from reduction driven gear using ST.

    ST 498077300 REMOVER

    Fig 1: Removing Ball Bearing From Reduction Driven Gear Using Remover
    G07914831Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the ball bearing on the reverse side with the same procedure as step Β 1.

    ST 498077300 REMOVER

    Fig 2: Removing Ball Bearing From Reduction Driven Gear Using Remover (Reverse Side)
    G07914832Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the snap ring of the parking gear.
    Fig 3: Identifying Snap Ring Of Parking Gear
    G07914833Courtesy of SUBARU OF AMERICA, INC.
  4. Using the ST, remove the parking gear.

    ST 18767AA000 REMOVER

    Fig 4: Removing Parking Gear Using Remover
    G05022312Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.