2012 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Rear Vehicle Speed Sensor: Removal

  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from battery.
  3. Lift up the vehicle.
  4. Clean the transmission exterior.
  5. Remove the bolts which connect the front exhaust pipe and rear exhaust pipe.
  6. Remove the bolts holding the heat shield cover, and move the heat shield cover to the rear.
  7. Disconnect the rear vehicle speed sensor connector.
    Fig 1: Identifying Rear Vehicle Speed Sensor Connector
    G06651999Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the rear vehicle speed sensor.
    Fig 2: Identifying Rear Vehicle Speed Sensor
    G05668784Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.