2012 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Input Clutch Pack Assembly

  1. Assemble the input clutch assembly to rear internal gear.
    Fig 1: Assembling Input Clutch Assembly To Rear Internal Gear
    G05022426Courtesy of SUBARU OF AMERICA, INC.
  2. Install the front carrier, and then install the snap ring.
    Fig 2: Installing Snap Ring And Front Carrier
    G05022425Courtesy of SUBARU OF AMERICA, INC.
  3. Install the thrust bearing.
  4. Install the front sun gear.
    Fig 3: Installing Front Sun Gear And Thrust Bearing
    G05022424Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.