Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Subaru Outback RFACTORY OEM SERVICE PROCEDURE
Section 6 (Engine Cooling System (H4SO)): General Description: Specification
WARNING: This page is about a different variant/trim than selected.
| Cooling system | Electric fan + Forced engine coolant circulation system | ||||
| Total engine coolant capacity | l (US qt, Imp qt) | Approx. 6.5 (6.9, 5.7) | |||
| Water pump | Type | Centrifugal impeller type | |||
| Discharge performance | Discharge rate | l (US gal, Imp gal) /min. | 200 (52.8, 44.0) | ||
| Pump speed - Discharge pressure | 6, 000 RPM - 225.4 kPa (23 mAq) | ||||
| Engine coolant temperature | 80°C (176°F) | ||||
| Impeller diameter | mm (in) | 76 (2.99) | |||
| Number of impeller vanes | 8 | ||||
| Pump pulley diameter | mm (in) | 60 (2.36) | |||
| Clearance between impeller and case | mm (in) | Standard | 0.5 - 1.5 (0.020 - 0.060) | ||
| Thermostat | Type | Wax pellet type | |||
| Starting temperature to open | 86 - 90°C (187 - 194°F) | ||||
| Fully opens | 95°C (203°F) | ||||
| Valve lift | mm (in) | 9.0 (0.354) or more | |||
| Valve bore | mm (in) | 35 (1.38) | |||
| Radiator fan | Motor input | Main fan | W | 90 | |
| Sub fan | W | 90 | |||
| Fan diameter / Blade | Main fan | 300 mm (11.81 in)/4 | |||
| Sub fan | 300 mm (11.81 in)/5 | ||||
| Radiator | Type | Down flow, pressure type | |||
| Core dimensions | Width x Height x Thickness | mm (in) | 687.4 x 340 x 16 (27.06 x 13.39 x 0.63) | ||
| Pressure range in which cap valve is open | kPa (kg/cm2 , psi) | Positive pressure side | Standard | 93 - 123 (0.95 - 1.25, 14 - 18) | |
| Service limit | 83 (0.85, 12) | ||||
| Negative pressure side | Standard | -1.0 to -4.9 or less (-0.01 - -0.05, -0.1 - -0.7) | |||
| Fins | Corrugated fin type | ||||
| Reservoir tank | Capacity | l (US qt, Imp qt) | 0.45 (0.48, 0.40) | ||
| Recommended materials | Item number | Alternative | |
|---|---|---|---|
| Coolant | SUBARU SUPER COOLANT (Concentrated type) | - | - |
| SUBARU SUPER COOLANT (Diluted type) | K0670Y0001 | ||
| Water for dilution | Distilled water | - | Soft water or tap water |
| Cooling system protecting agent | Cooling system conditioner | SOA345001 | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
