2012 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Air Intake Boot: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the cover (A) and clip (B) from air intake boot assembly.
    Fig 1: Identifying Cover And Clip Of Air Intake Boot Assembly
    G06648482Courtesy of SUBARU OF AMERICA, INC.
  2. Loosen the clamp (A) which connects the air intake boot assembly and air cleaner case.
  3. Loosen the clamp (B) which connects the air intake boot assembly and throttle body.
    Fig 2: Identifying Air Intake Boot Clamps
    G06648483Courtesy of SUBARU OF AMERICA, INC.
  4. Disconnect the blow-by hose and remove the air intake boot assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.