Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Subaru Outback RFACTORY OEM SERVICE PROCEDURE
Check Specified Position
WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
- If the stop light switch does not operate properly (or if it is not secured at the specified position), replace with a new part.
Specified position L:
2 mm (0.079 in)
- Measure the clearance between the threaded end of the stop light switch and the stopper.CAUTION: Be careful not to rotate the stop light switch.
Stop light switch clearance A:
0.8 mm (0.031 in)
- If it is not within the specification, adjust it by adjusting the position of the stop light switch.
CAUTION:
Be careful not to rotate the stop light switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.