Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Subaru Outback RFACTORY OEM SERVICE PROCEDURE
RH Side
- Remove the collector cover.NOTE: Follow the steps below when removing the collector cover.
- Pull up the two points at the rear (A).
- Pull up the two points at the front (B) while moving them forward.
- Release the fuel pressure. Refer to , RELEASING OF FUEL PRESSUREΒ , PROCEDURE, Fuel.
- Disconnect the ground cable from battery.
- Open the fuel filler lid and remove the fuel filler cap.
- Remove the air cleaner case and air intake boot assembly. Refer to AIR CLEANER CASE . Refer to AIR INTAKE BOOT .
- Remove the fuel pipe protector RH.
- Disconnect the connector from fuel injector.
- Remove the bolt which holds fuel injector pipe onto cylinder head.
- Remove the fuel injector while lifting up the fuel injector pipe.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.
