2012 Subaru Outback LimitedFACTORY OEM SERVICE PROCEDURE

General Tool

TOOL NAME REMARKS
Circuit tester Used for measuring resistance and voltage.
Thickness gauge Used for the clearance in reverse brake, forward clutch, transfer clutch and input clutch.
Caliper Used for measuring the clearance at the parts.
Spring scale Used for measuring the starting torque of the drive pinion.
TORX® bit T70 Used for removing and installing differential gear oil drain plug.
TORX® bit E16 Used for removing and installing the center support COMPL.
Straight pin remover Used for removing and installing transmission gear oil drain plug.
Deep socket Used for removing and installing the secondary pressure sensor.
NOTE: Use Ko-ken 3/8 12-point 27 mm (manufacturer product No. 3305M-27).
Push/pull gauge Used for measuring clutch clearance.
Chain sling Used for removing and installing transmission.
  • Length: 0.8 - 1 m (2.6 - 3.3 ft)
  • Load capacity: 1.2 t (2646 lb) or more
  • Diameter: 6 mm (0.24 in) or 6.3 mm (0.25 in)
  • Chain external width: 23.5 mm (0.93 in) or less
  • Chain internal width: 8.5 mm (0.33 in) or more
Screw shackle Used for removing and installing transmission.
  • Load capacity: 250 kg (551 lb) or more
  • Use two pieces.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.