2012 Subaru Outback F6-3.6L DOHCFACTORY OEM SERVICE PROCEDURE

Crankshaft Position Sensor: Service and Repair

Crankshaft Position Sensor

REMOVAL

1. Remove the collector cover.

NOTE: Follow the steps below when removing the collector cover.

1. Pull up the two points at the rear (A).
2. Pull up the two points at the front (B) while moving them forward.

Factory service manual diagram





2. Disconnect the ground cable from battery.
3. Loosen the clamp (A) which connects the air intake boot assembly.
4. Loosen the bolt (B) which secures the air intake boot assembly to the collector cover bracket.

Factory service manual diagram





5. Remove the air intake boot assembly, and move it to the left side wheel apron.


Factory service manual diagram





6. Remove the throttle body from the intake manifold.

NOTE: Do not disconnect the inlet and outlet hoses of engine coolant.

7. Remove the service hole plug.


Factory service manual diagram





8. Remove the crankshaft position sensor.


Factory service manual diagram





9. Disconnect the connector from the crankshaft position sensor.

INSTALLATION

Install in the reverse order of removal.

Tightening torque: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

Factory service manual diagram





Tightening torque:
Clamp (A) 3 N.m (0.3 kgf-m, 2.2 ft-lb)
Bolt (B) 6.5 N.m (0.7 kgf-m, 4.8 ft-lb)


Factory service manual diagram



Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.