Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Subaru Outback F4-2.5L SOHCFACTORY OEM SERVICE PROCEDURE
Manifold Pressure/Vacuum Sensor: Service and Repair
Manifold Absolute Pressure Sensor
REMOVAL
1. Disconnect the ground cable from battery.

2. Remove the cover (A) and clip (B) from air intake boot assembly.

3. Loosen the clamp (A) which connects the air intake boot assembly and air cleaner case.
4. Loosen the clamp (B) which connects the air intake boot assembly and throttle body.

5. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.

6. Disconnect the connector (A) from the manifold absolute pressure sensor, and remove the manifold absolute pressure sensor from the multi-function duct.

INSTALLATION
Install in the reverse order of removal.
NOTE: Use new O-rings.
Tightening torque: 2 N.m (0.2 kgf-m, 1.5 ft-lb)

NOTE: Align the clamp hole with the protrusion of the air intake boot assembly.

Tightening torque: Clamp (A), (B) 3 N.m (0.3 kgf-m, 2.2 ft-lb)

REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the cover (A) and clip (B) from air intake boot assembly.
3. Loosen the clamp (A) which connects the air intake boot assembly and air cleaner case.
4. Loosen the clamp (B) which connects the air intake boot assembly and throttle body.
5. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.
6. Disconnect the connector (A) from the manifold absolute pressure sensor, and remove the manifold absolute pressure sensor from the multi-function duct.
INSTALLATION
Install in the reverse order of removal.
NOTE: Use new O-rings.
Tightening torque: 2 N.m (0.2 kgf-m, 1.5 ft-lb)
NOTE: Align the clamp hole with the protrusion of the air intake boot assembly.
Tightening torque: Clamp (A), (B) 3 N.m (0.3 kgf-m, 2.2 ft-lb)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
