2012 Subaru Outback F4-2.5L SOHCFACTORY OEM SERVICE PROCEDURE

Camshaft Position Sensor: Service and Repair

Camshaft Position Sensor

REMOVAL

1. Disconnect the ground cable from battery.

Factory service manual diagram





2. Disconnect the connector from camshaft position sensor.

Factory service manual diagram





3. Remove the ignition coil. (LH side only)
4. Remove the bolt which secures camshaft position sensor to camshaft position sensor support.

Factory service manual diagram





5. Remove the bolt which secures camshaft position sensor support to camshaft cap LH.

Factory service manual diagram





6. Remove the camshaft position sensor and the camshaft position sensor support as a unit.

NOTE: Slide in the arrowed direction until the camshaft position sensor contacts the rocker cover LH.

Factory service manual diagram





7. Remove the camshaft position sensor from the camshaft position sensor support.

Factory service manual diagram





INSTALLATION

Install in the reverse order of removal.

Tightening torque:
Camshaft position sensor support: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
Camshaft position sensor: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.