Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Subaru Outback F4-2.5L SOHCFACTORY OEM SERVICE PROCEDURE
Body and Frame: Specifications
Assembly Of Exterior Parts
1. FRONT UNDER COVER
2. FLOOR UNDER PROTECTOR
3. FUEL TANK PROTECTOR
4. FRONT HOOD GRILLE
5. FRONT BUMPER
6. REAR BUMPER
- Sedan model
- OUTBACK model
7. MUD GUARD
8. COWL PANEL
9. SIDE SILL SPOILER
10. ROOF MOLDING
11. ROOF RAIL
12. TRUNK LID GARNISH
13. REAR GATE GARNISH
14. FRONT HOOD
15. FRONT FENDER
16. TRUNK LID PANEL
17. REAR GATE
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.