Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE
Steering Column: Removal
- Adjust the tilt position to the lowest position and lock the tilt lever.
- Remove the driver's airbag module assembly.
- Push in the snap pin using a hexagon wrench or equivalent wrapped with a protective tape to disengage the locks (3 locations).
- Disconnect the horn harness and airbag connector and remove the airbag module assembly. Refer to DRIVER'S AIRBAG MODULE, CURTAIN AIRBAG MODULE & PRETENSIONER Airbag Connector.
- Disconnect the horn harness.
- Remove the steering wheel.CAUTION:
- Always use the steering wheel puller for removal to avoid deforming the steering wheel.
- If the steering wheel has been removed, make sure that the roll connector is not turned from the original position.
- Disconnect the connector and remove the nut.
- Put alignment marks and remove the steering wheel.
- Remove the steering column cover.
- Lower the lever of the steering column.
- Release the claws and remove the screws, then detach the steering column lower cover.
- Separate the steering column upper cover and steering upper cover, and remove the steering column upper cover.
- Remove the universal joint.CAUTION: To prevent damage to the universal joint and error of handling force, make sure to remove the universal joint.
- Place alignment marks on universal joint.
- Remove the universal joint bolt and remove the universal joint.
- Remove the instrument panel lower cover.
- Remove the clips, and remove the instrument panel side cover LH.
- Remove the clips and data link connector, and remove the instrument panel lower cover under.
- Remove the screws and clips and release the claws, and remove the instrument panel lower cover while disconnecting the harness connectors.
- Remove the bolts, and remove the knee guard panel.
- Remove all connectors from the steering column.
- Remove the two bolts under instrument panel securing the steering column.
- Pull out the steering shaft assembly from the hole on toe board.CAUTION: Do not loosen the tilt lever when the steering column is not secured to the vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
