2012 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

On The Car Wheel Balancing

CAUTION:
  • Carry out the procedures after measuring the balance of each single tire.
  • Set the vehicle so that the front and rear wheels are the same height.
  • Release the parking brake during measurement.
  • Rotate each wheel by hands, and make sure it rotates without dragging.
  • Do not operate the clutch quickly and do not accelerate or decelerate suddenly during work.
  • When an error is indicated during engine drive, do not use the motor drive together.
  1. Set the rigid rack to the specified locations of side sill, jack up the front or rear two wheels of non-measuring side and set the pickup stands to two wheels of measuring side.
    Fig 1: Identifying Pickup Stand And Balancer Body
    G07911331Courtesy of SUBARU OF AMERICA, INC.
  2. For drive wheel, drive the tires with engine for measurement.
  3. For non-drive wheel, drive the tires from the on the car wheel balancer for measurement.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.