2012 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Converter Case: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly from the vehicle. Refer to , REMOVAL , Automatic Transmission Assembly.
  2. Remove the torque converter assembly. Refer to , REMOVAL , Torque Converter Assembly.
  3. Remove the transmission harness connector from stay.
  4. Remove the turbine speed sensor 1. Refer to , REMOVAL , Turbine Speed Sensor 1.
  5. Remove the air breather hose. Refer to , REMOVAL , Air Breather Hose.
  6. Remove the transmission hanger COMPL.
  7. Remove the ATF cooler inlet pipe and outlet pipe. Refer to , REMOVAL , ATF Cooler Pipe and Hose.
  8. Remove the converter case attachment bolts.
  9. Lay along the transmission body, and then remove the oil pan.
  10. Remove the three converter case mounting bolts (TORX®).

    ST 18676AA020 TORX® WRENCH

    Fig 1: Removing Converter Case Mounting Bolts Using Torx Wrench
    G05668863Courtesy of SUBARU OF AMERICA, INC.
  11. Separate the converter case by lightly tapping with plastic hammer.
  12. Remove the front differential assembly. Refer to , REMOVAL , Front Differential Assembly.
  13. Remove the oil seal from converter case.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.