Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE
Section 5 (Engine Cooling System (H6DO)): Radiator: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the radiator lower cushion.
- Install the radiator to vehicle.NOTE: Insert pins on the lower side of radiator into the radiator lower cushions on vehicle side.
- Install the radiator upper brackets.
Tightening torque:Β
12 N.m (1.2 kgf-m, 8.9 ft-lb)Β
- Connect the ATF hoses A and B.NOTE: Use a new ATF hose.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
