2012 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Air Intake Boot: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover.
    NOTE: Follow these procedures for removal of the collector cover.
    1. Lift up the rear side holding two positions (A).
    2. Lift up the front side holding two positions (B) while moving it in the forward direction of the vehicle.
      Fig 1: Removing Collector Cover
      G06651504Courtesy of SUBARU OF AMERICA, INC.
  2. Loosen the clamp which connects the air intake boot assembly and air cleaner case (rear).
    Fig 2: Locating Air Intake Boot Assembly And Air Cleaner Case Clamp
    G06651459Courtesy of SUBARU OF AMERICA, INC.
  3. Loosen the clamp (A) which connects the air intake boot assembly and throttle body.
  4. Loosen the bolt (B) which secures the air intake boot assembly and collector cover bracket.
    Fig 3: Identifying Air Intake Boot Assembly Clamp And Bolt
    G06651460Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect the blow-by hose and remove the air intake boot assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.