2012 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

General Diagnostic Chart: Inspection

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Vibration while cruising may be caused by an unbalanced tire, improper tire inflation pressure, improper wheel alignment, etc.
DIAGNOSTIC CHART

Symptom Possible cause Corrective action
Noise or vibration from propeller shaft  Center bearing Check the center bearing. Refer to CENTER BEARING FREE PLAY , INSPECTION, Propeller Shaft.
Runout of propeller shaft Check for deflection of the propeller shaft. Refer to RUNOUT OF PROPELLER SHAFT , INSPECTION, Propeller Shaft.
Loose or gap at connections Check the joints and connectors. Refer to JOINTS AND CONNECTIONS , INSPECTION, Propeller Shaft.
Check the spline and bearing. Refer to SPLINES AND BEARING , INSPECTION, Propeller Shaft.
Abnormal wheel vibration  Wheel is out of balance. Check the wheel balance. Refer to WHEEL AND TIRE SYSTEM .
Front wheel alignment Check the front wheel alignment. Refer to INSPECTION , Wheel Alignment.
Rear wheel alignment Check the rear wheel alignment. Refer to INSPECTION , Wheel Alignment.
Front strut Check the front strut. Refer to INSPECTION , Front Strut.
Rear shock absorber Check the rear shock absorber. Refer to INSPECTION , Rear Shock Absorber.
Front drive shaft Check the front drive shaft. Refer to INSPECTION , Front Drive Shaft.
Rear drive shaft Check the rear drive shaft. Refer to INSPECTION , Rear Drive Shaft.
Front hub unit bearing Check the front hub unit bearing. Refer to INSPECTION , Front Hub Unit Bearing.
Rear hub unit bearing Check the rear hub unit bearing. Refer to INSPECTION , Rear Hub Unit Bearing.
Noise from the underbody  Wheel is out of balance. Check the wheel balance. Refer to WHEEL AND TIRE SYSTEM .
Front wheel alignment Check the front wheel alignment. Refer to INSPECTION , Wheel Alignment.
Rear wheel alignment Check the rear wheel alignment. Refer to INSPECTION , Wheel Alignment.
Front strut Check the front strut. Refer to INSPECTION , Front Strut.
Rear shock absorber Check the rear shock absorber. Refer to INSPECTION , Rear Shock Absorber.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.