2012 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Spot Map Light: Removal

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from the battery.
  2. Remove the lens.
    • Model with sunroof
      Fig 1: Identifying Spot Map Light Lens - Model With Sunroof
      G05033376Courtesy of SUBARU OF AMERICA, INC.
    • Model with standard roof
      Fig 2: Identifying Spot Map Light Lens - Model With Standard Roof
      G05347112Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the four bolts used for mounting the spot map light.
    • Model with sunroof
      Fig 3: Identifying Spot Map Light Mounting Bolts - Model With Sunroof
      G05033377Courtesy of SUBARU OF AMERICA, INC.
    • Model with standard roof
      Fig 4: Identifying Spot Map Light Mounting Bolts - Model With Standard Roof
      G05347114Courtesy of SUBARU OF AMERICA, INC.
  4. Disconnect the harness connectors and remove the spot map light.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.