2012 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Check Warning Buzzer For Key Left In Ignition

Step Check Yes No
1 CHECK KEY WARNING SWITCH ALARM. 
  1. Insert the key into the ignition key lock.
  2. Open the driver's side door.
Does the buzzer sound from the meter? Normal Go to step 2. 
2 CHECK COMMUNICATION STATUS. 
  1. Prepare the Subaru Select Monitor.
  2. On << System Selection Menu >> display, select {Integ. unit mode}.
  3. On {Current Data Display & Save}, select {Key-lock warning SW}.
  4. Insert and remove the key.
Does the display change between ON → OFF? Go to step 3.  Check the ignition switch circuit. Refer to IGNITION KEY LOCK .
3 CHECK COMMUNICATION STATUS. 
  1. On {Current Data Display & Save}, select {Driver's door SW input}.
  2. Open and close the door.
Does the display change between ON ↔ OFF? Go to step 4.  Check the door switch circuit. Refer to DOOR LOCK CONTROL SYSTEM .
4 CHECK COMMUNICATION STATUS. 
  1. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
  2. On << System Selection Menu >> display, select {Integ. unit mode}.
  3. Select the {Diagnostic Code(s) Display}.
Is DTC being displayed? Perform the diagnosis according to DTC. Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . Go to step 5. 
5 CHECK COMBINATION METER. 
Perform the self-diagnosis of combination meter. Refer to , SELF-DIAGNOSIS DISPLAY MODE  .
Did the buzzer sound? Go to step 6.  Replace the meter case assembly.
6 CHECK COMBINATION METER. 
  1. Remove the combination meter.
  2. Attach the buzzer to another vehicle on which the buzzer operates normally to check its operation.
Did the buzzer sound? Replace the body integrated unit. Refer to BODY INTEGRATED UNIT . Replace the meter case assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.