2012 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Parameter Check

NOTE: The parameter data registered in the VDCCM is shown on the display.
  1. Connect the Subaru Select Monitor.
  2. On the << Main Menu >> display, select the {Each System Check}.
  3. On the << System Selection Menu >> display, select the {Brake Control System}.
  4. Click the [OK] button after the {VDC} is displayed.
  5. On the << Brake Control Diagnosis >> display, select the {Confirm on parameter}.
  6. On the {Confirm on parameter} display screen, check that the applied model and grade of the target vehicle are included, and click the [OK] button.
  7. If the applied model and grade of the target vehicle are not included on the {Confirm on parameter} display screen, perform parameter selection and registration. Refer to , PARAMETER SELECTION , OPERATION, Subaru Select Monitor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.