Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE
Rear Quarter Glass: Installation
- Cut the cartridge nozzle tip as shown in the figure, and set the adhesive in the sealant gun.
- Prepare and clean the adhesion surfaces of the glass and body using the same procedures as for the windshield glass. Refer to , INSTALLATION , Windshield Glass.
- Attach the dam rubber to the glass.
- Install the rear quarter glass in the same procedure as for windshield glass. Refer to
, INSTALLATION , Windshield Glass.
- Using a sponge, apply primer to the glass side and body side adhesive surfaces.
- Apply adhesive to the glass end back surface.NOTE: Use the molding terminal as a reference.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.