2012 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Impact Sensor: Operation

  1. IMPACT SENSOR SETTING USING SUBARU SELECT MONITOR
  2. Prepare the Subaru Select Monitor kit.
  3. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
  4. On << System Selection Menu >> display, select {Integ. unit mode}.
  5. Select {ECM customizing}.
  6. Perform impact sensor ON/OFF setting.
    • Installed: ON
    • Removed: OFF
  7. Perform impact sensor ON/OFF setting.
    • Installed: ON
    • Removed: OFF
  8. Turn the ignition switch to OFF and remove the Subaru Select Monitor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.