2012 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Check UART Communication

NOTE: When checking the GPS antenna, perform the check operation outdoors to improve the receiver sensitivity.
  1. Touch {Vehicle Signal Info.} on the << Dealer Diag Menu >> screen.
  2. Check that "ON" is displayed in the UART signal item.

    OK: Normal.

    NG: Abnormal. Check the signal line connection. If there are no problems, the unit could be faulty.

    NOTE: If the UART signal line connector is not connected, the marker line is not displayed when the rearview camera image is displayed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.