Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electrical Specification
- Body integrated unit
For I/O signals of the body integrated unit unit, refer to Body Control (Diagnostics). Refer to CONTROL MODULE I/O SIGNAL .
- Engine control module
For I/O signals of ECM, refer to Engine (Diagnostics). Refer to ENGINE CONTROL MODULE (ECM) I/O SIGNAL . Refer to ENGINE CONTROL MODULE (ECM) I/O SIGNAL . Refer to ENGINE CONTROL MODULE (ECM) I/O SIGNAL .
- Transmission control module
For I/O signals of TCM, refer to Automatic Transmission (Diagnostics). Refer to TRANSMISSION CONTROL MODULE (TCM) I/O SIGNAL . Refer to CVT(diag)-11, TRANSMISSION CONTROL MODULE (TCM) I/O SIGNAL .
- VDC control module
For I/O signals of VDC CM, refer to CONTROL MODULE I/O SIGNAL .
- Electronic parking CM
For I/O signals of electronic CM, refer to Parking Brake (Diagnostics). Refer to CONTROL MODULE I/O SIGNAL .
- A/C CM
For unit I/O signals of A/C CM, refer to HVAC System (Diagnostics). Refer to HVAC SYSTEM (DIAGNOSTICS) .
- Combination meter
For I/O signals of combination meter, refer to SYSTEM WIRING DIAGRAMS or SYSTEM WIRING DIAGRAMS .
- Data link connector
For I/O signals of data link connector, refer to Engine (Diagnostics). Refer to DATA LINK CONNECTOR . Refer to DATA LINK CONNECTOR . Refer to DATA LINK CONNECTOR .
* CAN sleep state:
Hold on for approx. one minute with ignition OFF and the doors, trunk, rear gate all closed.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
