Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Subaru Outback Base, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE
Oil Pump Chain: Removal
- Remove the transmission assembly from the vehicle. Refer to , REMOVALΒ , Automatic Transmission Assembly.
- Remove the torque converter assembly. Refer to , REMOVALΒ , Torque Converter Assembly.
- Remove the oil pump chain cover.
- Remove the seal ring from center support COMPL.
- Remove the driven sprocket from oil pump chain cover to remove the oil pump chain.NOTE: The driven sprocket is replaced as an assembly only, because it is a non-disassembly part.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
