Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Read Current Data: Operation
For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
- The support data list is as follows.
| Item | Display | Unit of measure |
|---|---|---|
| Engine speed signal | Engine Speed | RPM |
| Battery voltage | Battery Voltage | V |
| Accelerator position sensor | Accel. Opening Angle | % |
| Vehicle speed converted from front vehicle speed sensor signal | Front Wheel Speed | km/h or MPH |
| Lock-up duty solenoid set duty ratio | Lock Up Duty Ratio | % |
| AWD solenoid set duty ratio | Transfer Duty Ratio | % |
| Turbine speed signal converted from primary speed sensor signal | Turbine Revolution Speed | RPM |
| ATF temperature sensor signal | ATF Temp. | °C or °F |
| Manual mode switch signal | Manual Mode Switch | ON or OFF |
| Manual mode down switch signal | Down Switch | ON or OFF |
| Stop light switch signal | Stop Light Switch | ON or OFF |
| Manual mode up switch signal | Up Switch | ON or OFF |
| Drive range signal | D Range Signal | ON or OFF |
| Reverse range signal | R Range Signal | ON or OFF |
| AT OIL TEMP light 2 Hz blink condition | Diagnosis Lamp | ON or OFF |
| AT OIL TEMP light ON condition | ATF Temperature Lamp | ON or OFF |
| Parking range signal | P Range | ON or OFF |
| Neutral range signal | N Range | ON or OFF |
| AT learning mode condition | AT learning | Completed or not completed |
| Secondary speed sensor signal | Secondary Pulley Speed | RPM |
| Secondary fluid pressure sensor signal | Actual secondary pressure | MPa |
| Secondary solenoid set current | Sec. Sol. Set Current | mA |
| Secondary solenoid actual current | Sec. Sol. Actual Current | mA |
| Gear ratio | Actual Gear Ratio | - |
| Shift step in manual mode | Shift step in Manu. mode | - |
| Primary UP solenoid set duty ratio | Primary UP Duty | % |
| Primary DOWN solenoid set duty ratio | Primary DOWN Duty | % |
| F & R solenoid set current | Commanded Forward & Reverse Linear Solenoid Current | mA |
| F & R solenoid actual current | Actual Forward & Reverse Linear Solenoid Current | mA |
| Primary speed sensor signal | Primary Pulley Speed | RPM |
| Front vehicle speed sensor signal Front Wheel Speed RPM | Lock-up ON/OFF solenoid set Lock-Up ON/OFF Solenoid | ON or OFF |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.