2012 Subaru Outback Base, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE

Power Window Control Switch: Removal: Sub-Switch

  1. Remove the rear door trim. Refer to DOOR TRIM .
  2. Remove the power window switch panel.
    CAUTION: Do not damage the door trim with the switch panel.
    1. Insert a sheet of protective paper (a) between switch panel and door trim.
    2. Remove the screws and disconnect the connector.
    3. Disconnect the claws and then remove the power window switch panel.
      Fig 1: Inserting Sheet Of Protective Paper Between Switch Panel And Door Trim
      G07916330Courtesy of SUBARU OF AMERICA, INC.
  3. Disconnect the claws and then remove the power window sub-switch.
    Fig 2: Identifying Power Window Sub Switch And Claws
    G06653693Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.