Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Subaru Legacy Base, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE
Secondary Pressure Sensor: Inspection
- Remove the instrument panel lower cover. Refer to INSTRUMENT PANEL LOWER COVER EI-63, REMOVAL, Instrument Panel Lower Cover.
- Start and warm up the engine.
- Check the voltage of secondary pressure sensor with engine idling.
Connector & terminal
(B54) No. 17 (+) - No. 15 (-):
Specification
0.7 - 0.9 V
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
