Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Subaru Legacy Base, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE
Converter Case Cover: Assembly
- Install the plugs.NOTE:
- Use new O-rings.
- Apply CVTF to the O-ring.
Tightening torque:
25 N.m (2.5 kgf-m, 18.4 ft-lb)
- Using ST, install the center support COMPL.
ST 18270KA010 SOCKET (E16)
Tightening torque:
21.5 N.m (2.2 kgf-m, 15.9 ft-lb)
- Install the oil pump chain cover. Refer to , INSTALLATION , Oil Pump Chain.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
