2012 Subaru Forester X, Automatic TransFACTORY OEM SERVICE PROCEDURE

Non-Turbo Model

  1. Temporarily tighten the crankshaft position sensor plate, drive plate and reinforcement drive plate.
    NOTE: Align the knock pin hole of the crankshaft position sensor plate to the crankshaft knock pin to secure the knock pin.
  2. Set the ST.

    ST 498497300 CRANKSHAFT STOPPER

    Fig 1: Setting ST Into Crankshaft
    G07665579Courtesy of SUBARU OF AMERICA, INC.
  3. Tighten the drive plate mounting bolt in two stages.
    1. Tighten the drive plate mounting bolt.

      Tightening torque: 30 N.m (3.1 kgf-m, 22.1 ft-lb) 

    2. While checking the tightening angle with the ST, further tighten the drive plate mounting bolts.

      Tightening angle: 30° - 35° 

      ST 18854AA000 ANGLE GAUGE

      Fig 2: Tightening Drive Plate Mounting Bolts
      G07665580Courtesy of SUBARU OF AMERICA, INC.
  4. Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.