Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Subaru Forester F4-2.5L DOHCFACTORY OEM SERVICE PROCEDURE
Connecting Rod, Engine
Connecting Rods
Cap Bolts
Install new bolts
Please refer to Cylinder Block Removal and Installation for bolt tightening specifications and sequence. Part 2
Thrust Clearance 0.070 - 0.330 mm (0.0028 - 0.0130 in)
Oil Clearance 0.017 - 0.047 mm (0.0007 - 0.0019 in)
Cap Bolts
Install new bolts
Please refer to Cylinder Block Removal and Installation for bolt tightening specifications and sequence. Part 2
Thrust Clearance 0.070 - 0.330 mm (0.0028 - 0.0130 in)
Oil Clearance 0.017 - 0.047 mm (0.0007 - 0.0019 in)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.