Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Subaru Outback RFACTORY OEM SERVICE PROCEDURE
Rear Vehicle Speed Sensor: Installation
- Install the rear vehicle speed sensor.
Tightening torque:
7 N.m (0.7 kgf-m, 5.2 ft-lb)
- Connect the rear vehicle speed sensor connector.
- Install the heat shield cover. Refer to HEAT SHIELD COVER .
- Tighten the bolts which connect the front exhaust pipe and rear exhaust pipe.
Tightening torque:
18 N.m (1.8 kgf-m, 13.3 ft-lb)
- Lower the vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.