2011 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Section 13 (Clutch System): Flywheel: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Temporarily tighten the flywheel, and attach the ST.

    ST 498497100 CRANKSHAFT STOPPER

    Fig 1: Installing Flywheel Using Crankshaft Stopper ST
    G05003646Courtesy of SUBARU OF AMERICA, INC.
  2. Tighten the flywheel mounting bolts to the specified torque.
    NOTE: Tighten the flywheel attachment bolts gradually. Each bolt should be tightened to the specified torque in crisscross order.

    Tightening torque:Β 

    75 N.m (7.6 kgf-m, 55.3 ft-lb)Β 

    Fig 2: Identifying Flywheel Bolts Tightening Sequence
    G05003647Courtesy of SUBARU OF AMERICA, INC.
  3. Install the clutch disc and cover. Refer to INSTALLATIONΒ  .
  4. Install the transmission assembly. Refer to MANUAL TRANSMISSION ASSEMBLY .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.