2011 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Front Hub Unit Bearing: Assembly

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hub unit bearing to the ST securely.

    PREPARATION TOOL:Β 

    ST: HUB STAND (927080000)Β 

  2. Using a press, press the new hub bolts (b) until their seating surfaces contact the hub unit bearing (a).
    Fig 1: Pressing Hub Bolts
    G07914110Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.