Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Subaru Outback RFACTORY OEM SERVICE PROCEDURE
Check Specified Position
WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- If the stop light switch does not operate properly or if it is not secured at the specified position, replace with a new part.
Specified position L:
2.8 mm +1.5 mm -0 mm (0.11 in +0.06 in -0 in )
- Measure the clearance between the threaded end of the stop light switch and the stopper.CAUTION: Be careful not to rotate the stop light switch.
Stop light switch clearance A:
0.8 mm (0.031 in)
- Adjust the position of the stop light switch if the inspection result is not within the standard value. Refer to , ADJUSTMENT , Stop Light Switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.