2011 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Rear Disc Brake Assembly: Installation

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Before installation, remove mud and foreign matter from the caliper body and support.
  1. Before installation, check each part. Refer to , INSPECTION , Rear Disc Brake Assembly.
  2. Apply a thin coat of Molykote M7439 (Part No. 003602001) or the grease included with pad kit to the support.
    Fig 1: Applying Thin Coat Of Molykote M7439 (Part No. 003602001) And Grease Included With Pad Kit To Support
    G05662858Courtesy of SUBARU OF AMERICA, INC.
  3. Install the support to the rear axle housing.

    Tightening torque: 

    Mounting bolt: 66 N.m (6.73 kgf-m, 48.7 ft-lb) 

  4. Apply a thin coat of Molykote M7439 (Part No. 003602001) or grease contained in the pad kit to the pad clip.
    Fig 2: Applying Thin Coat Of Molykote M7439 (Part No. 003602001) And Grease Contained In Pad Kit To Pad Clip
    G05662870Courtesy of SUBARU OF AMERICA, INC.
  5. Apply a thin coat of Molykote AS880N (Part No. K0777YA010) or grease contained in the pad kit between the outer pad and shim.
    Fig 3: Applying Thin Coat Of Molykote AS880N And Grease Contained In Pad Kit Between Outer Pad And Shim
    G07666354Courtesy of SUBARU OF AMERICA, INC.
  6. Apply a thin coat of Molykote AS880N (Part No. K0777YA010) or grease contained in the pad kit to both surfaces of the inner pad inner shim.
    Fig 4: Applying Thin Coat Of Molykote AS880N And Grease Contained In Pad Kit To Both Surfaces Of Inner Pad Inner Shim
    G07666355Courtesy of SUBARU OF AMERICA, INC.
  7. Install the brake pad to the support.
  8. Install the caliper body to the support.

    Tightening torque: 

    Caliper bolt: 27 N.m (2.75 kgf-m, 19.9 ft-lb) 

  9. Install the brake hose bracket.

    Tightening torque: 

    Brake hose bracket: 33 N.m (3.4 kgf-m, 14.3 ft-lb) 

  10. Connect the brake hose using a new brake hose gasket.

    Tightening torque: 

    Union bolt: 18 N.m (1.84 kgf-m, 13.3 ft-lb) 

  11. Bleed air from the brake system. Refer to , BRAKE LINE , PROCEDURE, Air Bleeding.
  12. Install the rear wheels.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.