Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 61 (Body Control System Diagnostics): General Description: Inspection
Before performing diagnosis, check the following items which might affect body control system problems.
- Measure the battery voltage and check electrolyte.
Standard voltage: 12 V or more
Specific gravity: 1.260 or more
- Check the fuse condition.
Make sure that ampere of the fuse is setting value, and it is not blown out.
- Check the connecting condition of harness and harness connector.
- Confirm settings of body integrated unit are corresponded to vehicle equipment. Refer to , OPERATION , Registration Body Integrated Unit.
- Make sure that the User Customizing of the body integrated unit matches the vehicle equipment. Refer to , OPERATION , User Customizing.
- Confirm "Factory initial setting" of body integrated unit registrations is "Market".
- Confirm key illumination does not blink with ignition switch turned to ON.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
