Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Combination Switch (Light): Installation
- Before handling the airbag module, refer to CAUTION of "General Description" . .
- Do not allow harness and connectors to interfere or get tangled up with other parts.
- Align the center position of the roll connector. Refer to ROLL CONNECTOR .
- Align the alignment marks on the steering wheel and steering shaft.
- Install each part in the reverse order of removal.
Tightening torque:
Combination switch (light): 3.5 N.m (0.36 kgf-m, 2.6 ft-lb)
Driver's airbag module: 10 N.m (1.02 kgf-m, 7.4 ft-lb)
Steering wheel: 39 N.m (3.98 kgf-m, 28.8 ft-lb)
Clearance between column cover and steering wheel: 2 - 4 mm (0.08 - 0.16 in)
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.