2011 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Oil Level Switch: Installation

  1. Install the oil level switch to the cylinder block lower.
    NOTE:
    • Use new O-rings.
    • Apply a coat of engine oil to the O-rings.

    Tightening torque:Β 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)Β 

    Fig 1: Locating Oil Level Switch Mounting Bolt (View 2 Of 2)
    G06648595Courtesy of SUBARU OF AMERICA, INC.
  2. Hold the oil level switch harness with the clip.
    • Turbo model
      Fig 2: Locating Oil Level Switch Harness Mounting Clip (Turbo Model)
      G06648593Courtesy of SUBARU OF AMERICA, INC.
    • Non-turbo model
      Fig 3: Locating Oil Level Switch Harness Mounting Clip (Non-Turbo Model)
      G07910014Courtesy of SUBARU OF AMERICA, INC.
  3. Connect the connector of the oil level switch to the engine harness.
    Fig 4: Locating Oil Level Switch To Engine Harness Connector
    G06648592Courtesy of SUBARU OF AMERICA, INC.
  4. Install the under cover. Refer to FRONT UNDER COVER .
  5. Lower the vehicle.
  6. Refill the engine oil. Refer to , REPLACEMENTΒ , Engine Oil.
  7. Check the engine oil level. Refer to , INSPECTIONΒ , Engine Oil.
  8. Connect the battery ground terminal.
    Fig 5: Connecting Battery Ground Terminal
    G07909787Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.