Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Subaru Outback R PremiumFACTORY OEM SERVICE PROCEDURE
Various Indicators Illumination Control
Illumination of indicators on the combination meter are controlled as shown below according to shift pattern change.
| Condition | Display | |||
|---|---|---|---|---|
| Arrow mark | 7-segment | |||
| P, R, N range | Δ |
P, R, N | ||
| Normal D range | Δ |
D | ||
| Manual mode Semi SPORT shift |
Δ |
1 - 5 | ||
| Engine oil high temperature&engine high speed key | Δ |
- | ||
| At transmission failure | (1) |
- | ||
ATF high temperature is informed by illuminating "ATF TEMP". |
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
