Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Si-Drive Control
By changing the SI-DRIVE mode switch while driving in D range, shift control can be switched among three types according to each engine characteristics.
- I mode
When I mode engine characteristics is employed, shifting is performed at the optimum point to realize low fuel consumption. Compared to S and S# mode, slip lock-up range and full lock-up range are expanded.
- S mode
When S mode engine characteristics is employed, shifting characteristics is applied so that linear acceleration can be obtained and the acceleration is even in any vehicle speed range.
- S# mode
When S# mode engine characteristics is employed, shift timing is intended for higher speed than that of S mode and is set so that full engine performance can be obtained to provide driving with great response. In addition, adaptive control is operated more actively compared to I mode or S mode to realize sportier driving performance.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
